[Shotimes] Ride Height

[Dave Kegel]

OK.  Obviously Gen1 and Gen2 will have different measurements, at least
in the rear.

Dave

-----Original Message-----
From: shotimes-admin@autox.team.net
[mailto:shotimes-admin@autox.team.net] On Behalf Of James F. Ryan III
Sent: Thursday, July 03, 2003 8:25 PM
To: 'Robert Bruce'; 'SHOTIMES'
Subject: RE: [Shotimes] Ride Height


Finally got around to measuring mine.  I have SHO Shop linear springs,
Koni's and 225/55-16s.

FRONT:
	floor to fender:  26"
	rim to fender:  22-3/4"

REAR:
	floor to fender:  24-3/8"
	rim to fender:  20-3/4"



Jim Ryan
Wayne, NJ
'91 Plus - all white/mocha with fiberglass hood, rod shifter, & rear
spoiler

255 Lph fuel pump, SHO Shop can & horn, 80mm MAF, S&B cone filter, SHO
Shop HiFlow Y-pipe & cat-back exhaust, SHO Shop LPM, SHO Shop underdrive
pulleys, SHO Shop HiRevs Jr clutch & steel billet LiteWeight flywheel,
reinforced engine & trans mounts, SHO Shop TQ limiters, SHO NUT aluminum
SFBs, FPS '96 SHO front brakes, Carbotech F brake pads, Nook's full-body
SFCs, Koni adj struts, SHO Shop linear springs, 24mm FSB, 26mm RSB, SHO
Shop steel f&r STBs, Bridgestone Potenza RE-730 225/55-16, CATZ MSP fog
lights, police grille

 

 

 


> -----Original Message-----
> From: shotimes-admin@autox.team.net 
> [mailto:shotimes-admin@autox.team.net]
> On Behalf Of Robert Bruce
> Sent: Tuesday, July 01, 2003 5:55 PM
> To: 'SHOTIMES'
> Subject: RE: [Shotimes] Ride Height
> 
> F 25-5/8
> R 25-7/8
> Tokikos, Intrax, Yoko ES100 225/50, slicers
> 
> Robert Bruce
> 93 atx
> 
> 
> -----Original Message-----
> From: shotimes-admin@autox.team.net 
> [mailto:shotimes-admin@autox.team.net]On Behalf Of Dave Kegel
> Sent: Tuesday, July 01, 2003 4:40 PM
> To: 'SHOTIMES'
> Subject: RE: [Shotimes] Ride Height
> 
> 
> Mine is 26 1/2 to the floor, 22.75 to the rim.  This is with Eibachs, 
> but I lowered the front a little extra.
> 
> Dave
> 
> -----Original Message-----
> From: shotimes-admin@autox.team.net 
> [mailto:shotimes-admin@autox.team.net] On Behalf Of Dave Kegel
> Sent: Tuesday, July 01, 2003 3:24 PM
> To: 'Byrer'; 'SHOTIMES'
> Subject: RE: [Shotimes] Ride Height
> 
> 
> You want to measure from the bottom edge of the rim to the wheel well,

> to eliminate differences in tire sidewall.
> 
> Dave
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net http://www.team.net/mailman/listinfo/shotimes
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net http://www.team.net/mailman/listinfo/shotimes