[Shotimes] Power Steering Pump Removal/Install

[Epperly]

Did not have to remove the mount on the 92 MTX, first remove the pulley.
There are 3 bolts in the front and one high up in the back 10mm head I
think. Remove the pressure line 15mm or 16mm flare nut wrench (memory not
good on size but it was larger than my set) then hose clamp on supply line.
The pump will come out. As said this is for a MTX and I do not know the
difference as we do not own any ATX.
        Ken

Subject: [Shotimes] Power Steering Pump Removal/Install


> Hello everyone,
> I had my power steering pump go out rather spectacularily earlier today,
and now I need to replace it.  I have a 94 ATX.  Now, according to the
Helms, I have to remove the rear engine mount.  Is that necessary?  There
are no pictures of the process in my Helms and I am wondering where the rear
bolt for the pump is.  I am gathering that it is up behind the pump and that
the motor mount is in the way.  What size socket is needed for the lower
mount screw?  Last question, assuming the mount has to come out, does the
front one need to be loosened for it to be possible to jack up the engine to
remove the mount?  TIA for any help or suggestions.  JB
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes