[Shotimes] Re: Shotimes digest, Vol 1 #1836 - 19 msgs

[fwhittle@mindspring.com]

Yeah, the Helm's was real helpful in this instance:  To install, reverse Removal procedure.  The removal procedure says to pull the lower edge of the molding away from the vehicle to disengage the lower fasteners.  I don't see how reversing that procedure will result in the molding ending up behind those fasteners.  Probably anyone who's done this will understand what I mean.

Frank Whittle
'95 ATX

Date: Sat, 15 Mar 2003 20:46:28 -0500
From: Herman Anker <heranker@rogers.com>
CC: shotimes@autox.team.net
Subject: Re: [Shotimes] Gen II fenderwell cladding piece installation

Sorry for sounding blunt, but if I remember well, body is described pretyy 
vell in HElms manual. It hs been said a million times before, Helms manual 
will save SHO owners money down the road. Buy it on day 1 of ownership.

fwhittle@mindspring.com wrote:

>      I'm trying to install the aforementioned piece, the one that goes
behind the rear door.  I ended up breaking off the white clip at the top
(the plastic "welds" broke, so I'm thinking that epoxy would work fine to fix
it).  Is there a trick to installing this piece that I'm overlooking?  The
clip broke off when I tried to bend the piece enough to slide it over the
clips at the bottom.  Should I have a helper hold the top against the body
while I bend it to install the bottom?  Any better ideas?
>
> Thanks.
>
> Frank Whittle
> '95 ATX
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> <a target=_blank
href="http://www.team.net/mailman/listinfo/shotimes">http://www.team.net/mailman/listinfo/shotimes</a>

--
_______________________________________________________________________________

'95 ATX  ~139 000 km
Mods&Service page: <a target=_blank
href="http://hanker.tripod.com/sho.htm">http://hanker.tripod.com/sho.htm</a>
Ontario SHO enthusiast club: <a target=_blank
href="http://www.shopower.com/">http://www.shopower.com/</a>
High tech Automotive lighting faq: <a target=_blank
href="http://faq.auto.light.tripod.com">http://faq.auto.light.tripod.com</a>