[Shotimes] rod bearings

[Paul L Fisher]

Front one and rear one worst. Middle 4 all about the same.

Paul L Fisher
'93 Ford Taurus SHO Crimson Clearcoat ATX 172K Build date 11/18/1992
- K&N Panel filter, Tokico Struts, Eibach Springs, Dynomax cat-back, Holley
190lph fuel pump, FPS rebuilt ATX, 26mm rear sway bar, Performance-Plus
Stainless Steel Y-pipe, '96 brake upgrade, Proportioning valve plugs, Delrin
sub-frame bushings, Amsoil Series 2000 0W-30 oil, Amsoil Synthetic ATF.

SHO Club member http://www.shoclub.com/
Check out my web site http://www.paul-fisher.com/
Amsoil dealer http://www.paul-fisher.com/oil.htm

Get $5 free from Paypal! https://www.paypal.com/refer/pal=P3XEFFBFUFKN6

----- Original Message ----- 
From: "George Fourchy" <krazgeo@jps.net>
To: <shotimes@autox.team.net>
Sent: Saturday, May 03, 2003 11:55 AM
Subject: Re: [Shotimes] rod bearings


> On Sat, 3 May 2003 11:49:51 -0500, Paul Nimz wrote:
>
> >On my  '93 cylinders 6,3 & 4 were the worst.  The front three showed
normal
> >wear.  Mr. Porter surmised the rear cylinders are furthest from the oil
pump
> >and get less oil.
>
> My car was that way, too.  More copper on the rear uppers than anywhere
else.
>
> George
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes


---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.476 / Virus Database: 273 - Release Date: 4/25/2003