[Shotimes] rod bearings
sho2go
srfdude@cox.net
Sat, 3 May 2003 10:41:43 -0700
That would be a good, educated guess, except this wear pattern should be a
lot more common. At 140K, 2 of the center bearings (don't remember which)
were showing a little copper; neither end was in my car. On the oil forum
the filter testing is showing some filters (Mobil1, Purolator) dropping more
pressure than others. I use M1 and have never had the oil light flash or
other oil-related problems. Which filters have you been using?
Mike
----- Original Message -----
From: "Paul Nimz" <pmnimz@V8SHO.com>
To: "sho2go" <srfdude@cox.net>; <Shotimes@autox.team.net>
Sent: Saturday, May 03, 2003 9:49 AM
Subject: Re: [Shotimes] rod bearings
> On my '93 cylinders 6,3 & 4 were the worst. The front three showed
normal
> wear. Mr. Porter surmised the rear cylinders are furthest from the oil
pump
> and get less oil. One of the reasons I choose to go the Auto-RX treatment
> way to get the oil passages as clean as possible.
>
> Paul Nimz
> '97 TR SHO
> '93 EG mtx SHO