[Shotimes] Eagle Alloy brand Wheels

[Ron Porter]

42mm should be OK. If for some reason it's not, you can always use a spacer.
If you don't get enough offset for a wheel (too low an offset number), you
are kinda screwed.

Ron Porter

-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
On Behalf Of Carl Prochilo
Sent: Wednesday, September 17, 2003 12:26 PM
To: Ron Childs
Cc: shotimes@autox.team.net
Subject: Re: [Shotimes] Eagle Alloy brand Wheels


Yes that's the one.  4.25" converts to 108mm.  Our SHOs use a 5x108mm bolt
pattern.  The other consideration is the offset.  42mm should be okay.  I
believe if you wanted to go wider still you'd need to reduce the offset,
otherwise you would run the risk of rubbing the inners.
-- 
Cheers,
Carl Prochilo
92 Ultra Red Crimson - 201K

> Nice looking wheels. Is it the 1693-7770 (16x7.5/4.25-4.5) the size that
> fits the SHO? I do not see any prices there. What do they run?
>
> -Ron
>
>
> Carl Prochilo <gr8sho@prochilo.myserver.org> wrote:
> Looking for opinions on this brand.
>
> http://www.aewheel.com/wheels_detail.cfm?id=72
>
> This particular wheel will fit a SHO and weighs 19 lbs. Heavier than a
> slicer but still not bad considering the extra width.
> --
> Cheers,
> Carl Prochilo
> 92 Ultra Red Crimson - 201K
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes