[Shotimes] port matching the intake manifold

[James F. Ryan III]

worth the effort or a waste of time?

TB to intake manifold is fine.
Runners to tanks are very misaligned.
Manifold to heads could use some work on the manifold side.

If it's worth the effort, what bit(s) should I buy for my Dremel tool?


Jim Ryan
Wayne, NJ
'91 PLUS  all white/mocha with fiberglass hood, rod shifter, & rear spoiler

255 Lph fuel pump, SHO Shop can & horn, 80mm MAF, S&B cone filter, SHO Shop
HiFlow Y-pipe & cat-back exhaust, SHO Shop LPM, SHO Shop underdrive pulleys,
SHO Shop HiRevs Jr clutch & steel billet LiteWeight flywheel, reinforced
engine & trans mounts, SHO Shop TQ limiters, SHO NUT aluminum SFBs, FPS 96
SHO front brakes, Carbotech F brake pads, Nooks full-body SFCs, Koni adj
struts, SHO Shop linear springs, 24mm FSB, 26mm RSB, SHO Shop steel f&r
STBs, Bridgestone Potenza RE-730 225/55-16, CATZ MSP fog lights, police
grille