[Shotimes] cv joint explosion

[Ian Fisher]

Thanks

I seem to recall you saying that after my trans
started leaking after the rebuild. I just wasn't sure
which brand it was. Oh, and I am not putting blame on
you, just the seal. :)

How should I best remove the seal from the
transmission? I think I'll replace the driver's side
while the halfshaft is out and the fluid is drained
and I'll do the pass side when I swap in the 3.2
(hopefully in a month or so)

Ian

--- Mark Nunnally <marknunnally@joimail.com> wrote:

> > If I decide to replace the halfshaft seals in the
> > trans, how difficult are they to remove? Which is
> > preferred, Ford or Timken?
> 
> Timken!!!
> 
> After using the Ford ones for years (most of which
> tend to leak, even when
> new) the 2.99 Timken units (can get at your local
> AZ) seem to do the best
> 
> mark
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
> 



		
__________________________________ 
Do you Yahoo!? 
The all-new My Yahoo! - Get yours free! 
http://my.yahoo.com