[Shotimes] (FS) VAK Kit

[Paul L Fisher]

I believe our buddy Paul Nimz actually came up with the kit. It was just sold 
through Midwest SHO.
-- 

Paul L Fisher
'93 Ford Taurus SHO Crimson Clearcoat ATX 180K Build date 11/18/1992
- K&N Panel filter, Tokico Struts, Eibach Springs, Dynomax cat-back, Holley 
190lph fuel pump, FPS rebuilt ATX, 26mm rear sway bar, Performance-Plus 
Stainless Steel Y-pipe, Delrin sub-frame bushings, Amsoil Series 2000 0W-30 
oil, Amsoil Synthetic ATF.

SHO Club member http://www.shoclub.com/
Check out my web site http://www.paul-fisher.com/
Amsoil dealer http://www.paul-fisher.com/oil.htm



Quoting Christian Kesselring <ckesselring@sisna.com>:

> Vacuum Accessory Kill kit (Gen 1&2) for sale.  Make offer by email
> (kesselring@sisna.com).  Paypal preferred.  This kit was originally
> purchased from Midwest SHO for $98 on a group buy, but never installed due
> to selling the car.  For those not familiar with this mod, you hook it up
> to
> one of the vacuum lines, allowing the VAK to tell when the engine is at
> WOT.
> At that point, it cuts off all power from the alternator, effectively
> removing all the load placed on the engine by that accessory.  Has
> essentially the same effect as UDP's, but without the greater cost and
> installation time.  You need basic mechanical skills to install this mod,
> or
> a competent mechanic.
> 
> Christian Kesselring
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
> 


-------------------------------------------------
This mail sent through IMP: http://horde.org/imp/