[Shotimes] Cam position sensor
Mike
srfdude@cox.net
Sun, 15 Feb 2004 09:04:19 -0800
Its a very easy job, compared to most on the SHO. Takes all of 1/2 hour,
assuming you have a 1/4" drive ratchet set. Also need a phillips insert as
I recall. Pull the battery and move the power steering reservoir out of the
way. You may look in there and find the cam seal is leaking; one of mine
was so a quick trip to NAPA for the seal and back in business. The seal is
a bear to get out; post here for some tips on that.
Mike
----- Original Message -----
From: "bjshov8" <bjshov8@comcast.net>
To: "SHOTimes" <shotimes@autox.team.net>
Sent: Saturday, February 14, 2004 8:37 PM
Subject: Re: [Shotimes] Cam position sensor
> I have read advice that you pull the battery. Then you can get your arm
in
> there. I have not done this myself but I was envisioning a persons elbow
> located where the battery used to be, with your forearm going past the cam
> cover and your hand going right to the front of the sensor.
>
>
> > Is E9DZ-12126-A the correct part # for the cam position sensor formy
car?
> Any
> > tips on changing it?
> > --
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes