[Shotimes] Rod Knock Advice needed

[Paul L Fisher]

Yes, I have expereience but it was quieter afterwards. Could be you main 
bearings are shot as well?
-- 

Paul L Fisher
'93 Ford Taurus SHO Crimson Clearcoat ATX 180K Build date 11/18/1992
- K&N Panel filter, Tokico Struts, Eibach Springs, Dynomax cat-back, Holley 
190lph fuel pump, FPS rebuilt ATX, 26mm rear sway bar, Performance-Plus 
Stainless Steel Y-pipe, Delrin sub-frame bushings, Amsoil Series 2000 0W-30 
oil, Amsoil Synthetic ATF.

SHO Club member http://www.shoclub.com/
Check out my web site http://www.paul-fisher.com/
Amsoil dealer http://www.paul-fisher.com/oil.htm



Quoting leighsm@comcast.net:

> Anyone have any experience replacing rod bearings?
> Replaced mine, still knocks. Even Louder now than before.
> Bearings were well worn but had not spun.
> Knock was soft before and is now severe.
> Any ideas??????
> Lee
> 94 MTX 102k
> not as reliable as my old 250k '89!!
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
> 


-------------------------------------------------
This mail sent through IMP: http://horde.org/imp/