[Shotimes] keyless code, part 2: reprogramming a remote fob

[David Vaudreuil]

1. Close all doors and lock them.
2.insert and remove the ignition key in the ignition more than 6 times in 10 
seconds. Hazards should flash twice.(master remote is now earased.)
3. turn key to ACC.
4. press lock on the remote once. the hazards should flash twice. (this is 
for the new master remote)
Voila!!



Dave
92 MTX few mods
93 ATX stock
91 MTX with rear drums!!!
94 ATX for parts






----Original Message Follows----
From: "van Oss" <vanOss@centurytel.net>
Reply-To: "van Oss" <vanOss@centurytel.net>
To: "Kevin & Cheryl Airth" <clubairth@peoplepc.com>, 
<shotimes@autox.team.net>
Subject: [Shotimes] keyless code, part 2:  reprogramming a remote fob
Date: Thu, 22 Jan 2004 11:38:05 -0600

Okay, I dug around in the spare-tire well and found the module and code.
Thanks, Kevin.

Now I'd like some help from anyone who has reprogrammed a keyless module to
work with a new fob.  (I have a 92 shop, 93 shop, and 92 EVTM, and they
leave me with one question about REMOTE keyless.)

The 93 shop manual talks about a two-wire "J4" connector that I would access
by dropping the glove box.  I'm supposed to short across this connector
momentarily, then press any button on the fob, and voila, the car now
recognizes that fob.  Is that the procedure?

I've got the glove box lowered.  Nothing jumps out at me as being the J4
connector, a.k.a. Programming Connector.  Any tips?

VO

----- Original Message -----
Joe:
There should be a sticker on the module in the trunk on the drivers side.
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes

_________________________________________________________________
Tired of spam? Get advanced junk mail protection with MSN 8.  
http://join.msn.com/?page=dept/bcomm&pgmarket=en-ca&RU=http%3a%2f%2fjoin.msn.com%2f%3fpage%3dmisc%2fspecialoffers%26pgmarket%3den-ca