[Shotimes] subframe drop
cmichaelo@optonline.net
cmichaelo@optonline.net
Mon, 11 Oct 2004 15:47:05 -0400
Suppose one has solid subframe aluminum bushings, shouldn't you ALWAYS loosen the front bolts too?
Michael
94MTX,green,BOS+,Koni/Intrax,Baer,Corbeau
SHO items for sale: http://hometown.aol.com/cmichaelo/for_sale.html
----- Original Message -----
From: Kevin & Cheryl Airth <clubairth@peoplepc.com>
Date: Monday, October 11, 2004 1:28 pm
Subject: Re: [Shotimes] subframe drop
> Bob:
> Yes. I usually do the same thing for safety. If the drop in the
> back is
> not large enough for what I need to do, then I loosen the front
> ones a bit
> for more room. I see a couple of inches but don't let it hang
> unsupported if
> possible. Don't want to bend anything!!
> .
> .
>
>
>
> > OK, time for a stupid question. If you take out the back 2
> subframe bolts
> (to
> > get access to the rack) , how far down does everything fall
> (assuming you
> > don't support the subframe) ?? I am curious since I always put two
> hydraulic
> > car jacks under the subframe, before taking the bolts off. Will
> the engine
> &
> > tranny also drop down??
> >
> > Curious in Va
> > Bob
>
> >
> > Thanks to everyone for their suggestions. Seeing how the
> subframe is
> still
> > out of my car, along with the rack, this should be easy to do
> latertoday
> > as
> > I put it all back together.
> >
> >
> > Bruce J Malachuk
> >
> > * 94 Opal Frost MTX
>
> > Bruce:
> > The problem is the stud length will limit how many washers
> you can
> > install.
> > Most people can get 2, maybe 3 per side. Anymore and you don't
> haveenough
> > threads left for the nut. At Lowe's I found the hardened
> washers. 14 mm
> > full
> > height. This will get you about 3/8". Not enough but an
> improvementanyway.
> > Some people have also used 2" fender washers with a 1/2" diameter
> center.
> > These are thinner and you can stack more about 6 per/side.
> Plus with the
> > thin washers you can raise the rack and fit them in. The
> thicker washer
> > require a subframe drop. I prefer to loosen the 2 rear
> subframe bolts
> > because you have a bit more room to work!
> > .
> > .
> >
> >
> >
> > > Bout how high should I have to raise the rack for using
> Intrax springs
> > with
> > > no coils cut? I know I read about it here, but wanted to get the
> > > thoughts here online before I put the rack back in my car :-)
> > >
> > > Bruce J Malachuk
> > >
> > > * 94 Opal Frost MTX
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes