[Shotimes] Blend door problem

[James White]

I have maybe the same problem.

But maybe more important, because the high where I was today was 
10 above!

It has been too cold to spend much time working the SHO, but I did 
discover that pushing the "MAX COOL" button and then mashing the 
temp buttons up to 90 resulting in providing warm air out of the 
dash vents.

What, I think that we have to do is how to figure out is how to get 
the recircular vent air door to close out the outside air.  Then 
warmer inside air will bb run through the system.  

This recircular air door controls the outside (very cold) air from 
getting into the system.  Keep this cold air out, and you will have 
warm air to keep your toes warm.

But, at 8 degrees, very dark and 300 miles from home, I have as yet 
to figure out just how to keep this recircular air door closue tight.


regards, Jim White



At Wednesday, 7 December 2005, "Harry Seaman" <hjseaman@earthlink.
net> wrote:

>The blend door actuator motor in my '95 is going, I fear.  Repetetive 
>snapping, thumping noises coming from the nether regions. I know 
I'll have 
>to replace the motor at some point, but...since I'll only be needing 
it in 
>the full heat position for the next couple of months, I'm wondering 
if it 
>would be possible to 1) find, and 2) disconnect, the electrical 
cable going 
>to the blend door motor, so the door just stays in the hot position.
Has 
>anyone done this?
>
>Thanks
>Harry
>95mtx 
>_______________________________________________
>Shotimes mailing list
>Shotimes@autox.team.net
>http://www.team.net/mailman/listinfo/shotimes