[Shotimes] 89 sho dyno charts posted

[Donald Mallinson]

I finally got the prints of my dyno test of the new .20 cam setup.  So I 
don't use up bandwidth, I have put the dyno charts up on the shoclub.com 
web site.  here is a short link:

http://makeashorterlink.com/?A2625163B

I could not get the new charts on disk so I had to scan all of them.

to my way of thinking, this is a much weaker engine than before.

What can I do to get some power back...basically what I see is that 
unless I want the engine to live above 6000 rpm, I am have gone way 
backwards in torque and  HP.

Exactly NOT what I wanted.

Reminder.  The engine was basically a BOS with a Pro Flow 77mm with no 
chip.  Ran great.

Now same except with EH runners, BBB, Josh's .20 cams.

Engine is healthy.

What is it going to take to get back some of the power and torque below 
6000 rpm except just putting it back to the way it was?  I expected to 
have to run the engine a bit harder, but this is not good what I see on 
these charts.

any and all advice appreciated

Don Mallinson