[Shotimes] idler pulleys, ID and OD

[Jim & Debbie Leyden]

That part number equates to a standard NSK bearing with the exception of the
last three digits.  A while back I contacted NSK here in Atlanta and they
tried to figure out exactly what the DWA stood for.  They were unable to
obtain the print from Japan since it is a proprietary part.  The best that
they could come up with is that the bearing has a non standard radius or
something to that tune.  They did tell me that they didn't think that it was
for increased loading or anything critical like that.

Jim

-----Original Message-----
From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
On Behalf Of Paul Nimz
Sent: Friday, June 10, 2005 5:38 PM
To: `V6 SHOtimes; vanOss@centurytel.net
Subject: Re: [Shotimes] idler pulleys, ID and OD

They are nearly unobtanium.  There was a guy from Canada on SHOforum
(Ishodu)
had a few for $30 each.  The NSK BD20-15DWA   20mm ID 37mm OD and 15mm
thick.

If you find a good source I would like to know.

Paul


On 6/10/2005 3:23:23 PM, van Oss (vanoss@centurytel.net) wrote:
> Anyone got reliable inner and outer diameters on the idler pulley
> bearings?
>
> VO
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes

-- 
No virus found in this incoming message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.6.6 - Release Date: 6/8/2005
 

-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.323 / Virus Database: 267.6.6 - Release Date: 6/8/2005