[Shotimes] 94 ATX Timing Belt Idler Pulley EXACT Replacement

[Paul Nimz]

How about the MTX/V8 idler pulley bearings?  The NSK BD20-15DWA   20mm ID 37mm
OD and 15mm thick

Paul


On 5/23/2005 10:07:25 AM, Kevin & Cheryl Airth (clubairth@peoplepc.com)
wrote:
> John:
> Good information but there is a MUCH cheaper and simpler repair. The
> timing
> belt AND fan belt idlers on the ATX SHO use the same bearing. Not
> all the
> fan belt idlers are the same so look carefully.
> That's all you really need
> to replace. Yes it is the same bearing as used in the Nissan A/C pulley you
> found.  Size is 35mm X 55MM. Part # NAC35BG05S10GST2F. Cost about $28.
> This number is on the bearing itself but is sometimes hard to see.
> Some people have had problems finding this. I have a local bearing house
> that keeps these in stock if you can't
> find it.
> .
> .
>
>
>
> > I hope that this information can be of some benefit.
> >
> > Recently my timing belt idler pulley went south on my 94 3.2L SHO
> (135Kmiles) also damaging the middle and lower covers.   Having just
> eplaced
> the tensioner pulley and TB a few months ago I tried in vein to get a new
> F3DZ-6M250-A Ford replacement pulley (NTN 2TS2-DF0716LH bearing with dark
> green stripe) with no success.  I scowered the internet and did find a
> few
> used sources one of which I purchased but turned out to be a dry
> bearing.  I
> rece