[Shotimes] New +20 cam dyno results

[Donald Mallinson]

Alan,

again, there isn't much chance of that since the new setup at no point 
after the torque curve gets near peak comes close to the old one.  A 
loss of about 10 lb ft across the board with the old setup doing 190 
even before the runners open and the new one never getting over 183, 
doesn't matter where you take the reading, there is a loss.

Don

Alan Fanning wrote:

>Mark may have already responded (I'm on digest), but I'm sure he was
>referring to making more torque vs the old cams when measured at the same
>(higher) rpm. Thus, more HP at that higher rpm.
>
>    Alan
>
>
>wrote:
>
>  
>
>>well, since the peak of the new cams is well below the old set-up, and
>>the curves are somewhat similar, then there is not going to be much chance
>>of any time when there will be more torque with the new setup unless
>>computer tuning does some magic or I add the adjustable sprockets.
>>
>>Don
>>
>>Mark Nunnally wrote:
>>    
>>
>_______________________________________________
>Shotimes mailing list
>Shotimes@autox.team.net
>http://www.team.net/mailman/listinfo/shotimes