[Shotimes] Bad Ball Joints or Wheel Bearings?
Juillerat, Aaron J
aaronj@autojectors.com
Fri, 4 Nov 2005 09:26:34 -0500
Ian, what are you referring to when you say "think slicer hat"?
-A.J.
-----Original Message-----
From: Ian Fisher [mailto:dataflash@yahoo.com]
Sent: Friday, November 04, 2005 7:33 AM
To: George Fourchy; shotimes@autox.team.net
Subject: Re: [Shotimes] Bad Ball Joints or Wheel Bearings?
If you are running the thick slicer hats with longer
studs, expect to run through wheel bearings somewhat
frequently. For me, that's reason #542 to get thinner
hats and thicker rotors and dump my slicers forever.
It's a good idea if you have ample spoke to caliper
clearance with your rims.
Ian
--- George Fourchy <krazgeo@comcast.net> wrote:
> That was immediately after I had
> the bearing replaced when the old one had about an
> inch of play. These were (still
> are) Scott Chan's Wilwood knuckles that were new
> from TCE in about 1996 or so. That
> was the left side....the right side is still
> original, and at last check (2004) had
> hardly any measurable play.
>
__________________________________
Yahoo! Mail - PC Magazine Editors' Choice 2005
http://mail.yahoo.com
_______________________________________________
Shotimes mailing list
Shotimes@autox.team.net
http://www.team.net/mailman/listinfo/shotimes