[Shotimes] Subframe Adjustment

[Alan Fanning]

I've finally got a weekend free to work on our '95 ATX SHO. I need to get
the subframe shifted over about 1/8'th inch to even out the camber. I've got
the four SF bolts backed off about 4-6 turns and am trying to figure out how
to pry the SF sideways.

I see the alignment holes just aft of the front pair of SF mounts, but don't
seem to get any real motion out of the SF when I put a pry bar in there and
fiddle around.

I'm also a little puzzled as to how I can get simple lateral motion by
prying on one of those holes. It seems like I would just be spinning the
subframe around the diagonally opposite point.

Could somebody that's done this give me a clue as to how it's done?  Do I
need to remove or loosen the bolting to any other pieces to make this work?

Thx.

    Alan