[Shotimes] Half-shaft for '95 ATX

[Alan Fanning]

After the CV boot of my '91 SHO blew up and spred it's guts all over the
inside of my wheelwell at Thunderhill Park last summer, I bought a new
half-shaft from Raxles and was very pleased. However, since the car in
question is not driven hard, and the existing boot has not actually failed
yet, I may try just replacing the cracked boot with a new one.  Is this a
practical alternative? Car only has ~84k on it.

    Alan


wrote:

> Try raxles.com.   Paul Nimz has had good results, lifetime warranty and
> their prices are not bad.
> 
> -----Original Message-----
> From: shotimes-admin@autox.team.net [mailto:shotimes-admin@autox.team.net]
> On Behalf Of Ian Fisher
> Sent: Monday, September 05, 2005 12:33 AM
> To: Alan Fanning; SHOtimes
> Subject: Re: [Shotimes] Half-shaft for '95 ATX
> 
> They are different. I'd get a reman halfshaft from any place that offers a
> lifetime warranty. I think that AZ sells CCW halfshafts. I've been running
> them for a few months on my mtx without problems. Previously I had A1's that
> were replaced under warranty from AZ after they picked up the selling store
> via merger.
> 
> Ian
> 
> --- Alan Fanning <Awfanning@earthlink.net> wrote:
> 
>> Are the half-shafts on the ATX cars different than on the MTX cars?  I
>> have a CV boot going south on my '95 ATX.
>> 
>> Any experience with Autozone half-shafts out there?
>> 
>> Thx.
>> 
>>     Alan
>> _______________________________________________
>> Shotimes mailing list
>> Shotimes@autox.team.net
>> http://www.team.net/mailman/listinfo/shotimes
> Tired of spam?  Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes