[Shotimes] Front wheel bearing replacement

[Leigh Smith]

I'll bet you can get the bearings for less than $150.
Not a lot of fun pulling the spindle, but not much different than doing
struts.
If you can do one, you can do the other, and save the labor.
Not expensive to have it pressed on/off at a shop if you hand them the
spindle.
$75 vs $350.
Lee

(Watch the abs sensor line)
----- Original Message ----- 
From: "Peter Chase" <pbchase@gmail.com>
To: "Sholist" <shotimes@autox.team.net>
Sent: Wednesday, September 07, 2005 6:34 PM
Subject: [Shotimes] Front wheel bearing replacement


> I was told by NTB that my RF wheel bearing and hub need to be replaced.
They
> quoted me 150 parts and 200 labor. I know I can get the part for about
half
> that, but how difficult a job is it to replace the bearing and hub? Any
> special tools needed? Do I have to remove the whole spindle to get the
> bearing pressed out?
>  Thanks,
>  Peter
> _______________________________________________
> Shotimes mailing list
> Shotimes@autox.team.net
> http://www.team.net/mailman/listinfo/shotimes