[Shotimes] Crankshaft Pulley bolt
James White
greensho@crown.net
Thu, 9 Feb 2006 23:51:01 -0600
I and many others that have been around for a while have found that
the use of starter power is by far the easiest way to remove the
crank balancer bolt. Unless you have a really good and strong impact
this is the way to go.
If you are worried about rounding this bolt more than it is, use
a bunch of Super Glue Gell between the socket and the bolt. Let
it dry for several hours. Then crank the motor with the DIS plugs
disconnected.
Use #16 ga. wire to hold the wrench in place. When you have this
bolt out you should be able to use torch heat to get the bolt out
of the socket.
regards, Jim White - greensho@crown.net
'95 MTX - 196k
'93 MTX - 284k
At Thursday, 9 February 2006, "Raymond Aikens" <raymond@aikens.com>
wrote:
>Does anybody have any ideas for getting the center crankshaft-balancer
>pulley BOLT OFF?
>
>I don't like the crank the engine while the ratchet is attached
idea. The
>bolt is getting worn down.
>_______________________________________________
>Shotimes mailing list
>Shotimes@autox.team.net
>http://www.team.net/mailman/listinfo/shotimes