[Spits] GT6 Rear Hub Bearings

[Daniel Parrott]

I should have mentioned that I have a 1972 GT6 MKIII with a rotor flex rear
axle.  I can get the hub off, but the axle seems hard to turn, due to maybe
not enough end float with the end nut.


Dan Parrott
Savannah, Ga
1980 Triumph Spitfire "PJ"
1972/1978 Spit Six Project car "Joseph"




-----Original Message-----
From: Jim Cullen [mailto:ccullen16 at cogeco.ca] 
Sent: Sunday, January 17, 2010 7:03 PM
To: Daniel Parrott
Subject: Re: [Spits] GT6 Rear Hub Bearings

Not sure if this is exactly the type of thing your looking for, but this 
video was helpful when I did my rear hubs this past summer.

http://www.youtube.com/watch?v=Qvbi1UZpHPI

Jim Cullen
----- Original Message ----- 
From: "Daniel Parrott" <parrotthead01 at comcast.net>
To: "'Spitfire list'" <spitfires at autox.team.net>
Sent: Sunday, January 17, 2010 2:31 PM
Subject: [Spits] GT6 Rear Hub Bearings


> Does anyone have access to a reference to set of step-by-step directions 
> for
> the replacement of the rear hub bearings, hubs and axels for a 1972 GT6? 
> I
> need guidance to make sure that the bearings are seated with the proper 
> end
> float.
>
>
>
> TIA
>
>
>
> Dan Parrott
>
> Savannah, Ga
>
> 1980 Triumph Spitfire "PJ"
>
> 1972/1978 Spit Six Project car "Joseph"
>
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> Suggested annual donation  $11.47
>
> You are subscribed as ccullen16 at cogeco.ca
>
> Spitfires at autox.team.net
> http://autox.team.net/mailman/listinfo/spitfires
>
> http://www.team.net/archive