[Spridgets] Crankshaft Spigot bearing removal

[Pat]

Call me a bit daft, But wouldn't it be the same as the I.D. of the
aforementioned bearing? 

-----Original Message-----
From: spridgets-bounces+pelliott=innercite.com at autox.team.net
[mailto:spridgets-bounces+pelliott=innercite.com at autox.team.net] On Behalf
Of Daniel1312 at aol.com
Sent: Wednesday, September 05, 2007 2:05 PM
To: spridgets at autox.team.net
Subject: [Spridgets] Crankshaft Spigot bearing removal

Hi List,

I've discovered that my engine has had a new spigot bearing fitted to it.  
Unfortunately I need to remove it as my car runs a Ford based 5 speed
conversion 
which uses a spigot adaptor.

I recall the recommended technique is to fill the end of the crank with 
grease and hydraulic the spigot out by the use a drift or old gearbox input
shaft.  
I don''t have an old gearbox or input shaft to use let alone measure any
more 
than I have a drift of the right size.  I don't mind buying a drift of the 
right size but need to know the size.

So, anyone have the size?

Thanks

Daniel1312   
_______________________________________________
pelliott at innercite.com

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets