[Spridgets] A series head ??
uniquelittlecars at yahoo.com
uniquelittlecars at yahoo.com
Sun Jan 13 10:07:01 MST 2008
New Question - I found a head in the back of my garage. i know from the casting it is from a 948cc "A" Motor from a Morris vehicle. Ok - Here is my question. Is there a chart or a formula to figure the CC of the head? The head is not on a motor. I have got a ruff figure on another head by using liquid. Then cranked the motor with and old towel over the head to catch the fluid. I was only gas so i could have just fired the motor. I figured it may cause problem so i used the towel method. I am assuming you take a flat and messure to the bottom. How do you figure in the curves or round edges to get your number.
Vigil
"Robert E. Shlafer" <pilotrob at webtv.net> wrote: Stock Spridget 1275's were 21.4cc's.
Cap'n. Bob '60 :{)
-----Original Message-----
From: Lester
Sent: Saturday, January 12, 2008 10:13 PM
To: bugeye at yahoogroups.com, Spridgets net
Subject: [Spridgets] A series head ??
Ok, so what is the size of the combustion chamber? I measured 22cc's
on the one I have. anyone know if it is stock or has it been massaged?
Thanks,
Lester
You are subscribed as pilotrob at webtv.net
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
You are subscribed as uniquelittlecars at yahoo.com
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
---------------------------------
Never miss a thing. Make Yahoo your homepage.
More information about the Spridgets
mailing list