[Spridgets] tappet threads?

[Hal Faulkner]

Bill
I measure 26TPI Definitely NOT 1.0mm pitch.  The od of the threads is .2752"
or 6.991mm.  My hole guage says 9/16". Since I don't have a thread mic I
can't say exactly! Hmmm, maybe I need to order one....
Hal

-----Original Message-----
From: spridgets-bounces+hal=katemuir.com at autox.team.net
[mailto:spridgets-bounces+hal=katemuir.com at autox.team.net]On Behalf Of
Bill L
Sent: Tuesday, June 03, 2008 8:38 PM
To: spridgets at autox.team.net
Subject: [Spridgets] tappet threads?


Hello Spridgets,

  anyone out there know offhand what the threads/inch of the tappet
  adjusters?....i've been assuming they are 14/28, .. National Fine
  Thread...

--
Best regards,
 Bill                          mailto:pythias at pacifier.com
 '66 Sprite HAN8L49403
  "I tried to think but nothing happened!" - Curly