[Spridgets] Sleeving master/brake cylinders - Stainless vs. Brass

[Dean Hedin]

That's a bummer.   I guess you'll have to save it for that future concours 
Bugeye.

If I'm going to spend the money or effort in resleeving then I want to do it 
in
stainless, and I don't ever want to have to go there again..

I am sure that the brass the outfits are using is durable but I can still 
imagine
corrosion and wear in brass after a couple years, especially in the master 
cylinder.

What I can't figure is why does'nt everybody use stainless? The material 
cost is not
the issue here.


----- Original Message ----- 
From: "Frank Clarici" <spritenut at comcast.net>
> Dean
>
> I had a local shop sleeve one of mine, he was supposed to sleeve it from 
> 7/8 to 3/4 but when I got it back, it was 7/8.
> It was a trial thing and since it's still 7/8, I have not tried it.