[Spridgets] Which rear engine plate
Mike/Donna Carpenter
mail4carpenters at peoplepc.com
Tue Mar 4 08:46:59 MST 2008
Excellent. Thanks Peter. I knew there was more behind that.
Thanks,
Mike C
-----Original Message-----
>From: Peter C <peter at nosimport.com>
>Sent: Mar 4, 2008 10:37 AM
>To: spridgets at autox.team.net
>Subject: Re: [Spridgets] Which rear engine plate
>
>Actually Mike, it should match the clutch. Or rather, you need a 1275
>thick plate for a 1275, so the clutch components and flywheel should
>match. If they don't then you have to combine the right clutch parts.
>3 different release bearing heights. 3 pressure plate heights, stuff like that.
> Peter C.
>--------------------
>At 06:54 AM 3/4/2008, Mike/Donna Carpenter wrote:
>
>>I know that you guys have probably answered this question a million
>>times. However, I'm asking again.
>>
>>The engine back plate that you put on, is it supposed to match the
>>engine as in thick for 1275, thin with bent edge for 948 and
>>1098? Or is the engine back plate supposed to match the
>>transmission that will be used?
>>
>>Why is there a difference and why must they be paired up?
>>
>>Thanks,
>>
>>Mike Carpenter
________________________________________
PeoplePC Online
A better way to Internet
http://www.peoplepc.com
More information about the Spridgets
mailing list