[Spridgets] Rear Springs Source?
Bill L
pythias at pacifier.com
Sat Nov 29 17:11:15 MST 2008
Hello Michael,
Seems that they all seem to "take a set".. If you change the
springs from the driver's side to passenger side, you'll most
likely find that the thing still lists... and still to the
DRIVER's SIDE! Weird huh?....
BUT... try this... go the the car. look at the FRONT end. see if
the rear sag is causing the passenger side front to raise up? if
so go to the back of the car and lift the driver's side rear and
see if the WHOLE car levels out?...
if so.. you can "fix" the listing by putting spacers under the
spring pans on the passenger side front suspension! this can be
done without taking the suspension apart, or the spring pans off.
You need to
get longer bolts. get some 3/8 flat washers. loosen all the bolts
but remove NONE, giving some space under the spring pans... then
remove ONE bolt. replace it with the longer one inserting the
washers between the pan and the A arm. then do the diagonal
opposite one. tighten 'em up a little, then do the other two.
when i did this, i figured i needed 1/2 the spacing difference
between the driver and passenger side... it wasn't enough, but
the car IS a lot better.... Plus it improved the front suspension
geometry since the front now sits (nearly) level.
--
Best regards,
Bill L. mailto:pythias at pacifier.com
'66 Sprite MKIII HAN8L49403 "the red thing"
* "This game is foul," Tom groused.
More information about the Spridgets
mailing list