[Spridgets] john , NJMP in millville info?
Guy Weller
guy.weller at tiscali.co.uk
Thu Sep 25 01:05:55 MDT 2008
Matt,
<<the timing gear was "rekeyed" to 102 teeth..>>
Not sure that really makes any sense. But "Rekeyed to 102 DEGREES might.
The cam shaft may have been set to 102 degrees ATDC for max lift on #1 inlet
valve. This could be done with vernier timing gears, a stepped woodruff key
or a re-cut keyway.
Depending on the cam shaft specification 102 degrees could make sense.
Guy
-----Original Message-----
From: spridgets-bounces+guy.weller=tiscali.co.uk at autox.team.net
[mailto:spridgets-bounces+guy.weller=tiscali.co.uk at autox.team.net]On
Behalf Of Matt Hagopian
Sent: 25 September 2008 06:51
To: shop at justbrits.com
Cc: Spridgets
Subject: Re: [Spridgets] john , NJMP in millville info?
Ed,
my grandfather blew it, never went over 6500 there was a 7000 rev limit chip
on the msd. I think the clearances were incorrect and I think the timing was
incorrect. i was told the timing gear was "rekeyed" to 102 teeth... if that
means something to you.
You are subscribed as guy.weller at tiscali.co.uk
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
More information about the Spridgets
mailing list