[Spridgets] measurement needed (Bugeye)

Jim F. jimndi at frontiernet.net
Mon Mar 9 18:51:38 MST 2009


Well it just needs to be wide enough to carry the locking pins, right? put 
the two rods together with a little grease on them, and thats your width.

J
1960 Bugeye

----- Original Message ----- 
From: "Frank" <spritenut at comcast.net>
To: "Jim F." <jimndi at frontiernet.net>
Cc: "Spridgets" <spridgets at autox.team.net>
Sent: Monday, March 09, 2009 9:47 PM
Subject: Re: [Spridgets] measurement needed (Bugeye)


>
> Thanks for the measurements, and I tried to make this compound piece a
> few times, looks like I can only make it square.
> So what do you guys think.....1.75 wide all the way or 1.25 all the way.
> Trying to make it tapered with 2 bends and an 1" rise just doesn't
> happen at home with basic tools even a metal brake.
> Since this car is already 2 cars cut and welded together, some minor
> changes to the bonnet will never be noticed ;)
> Everything from the grille down on this bonnet, if it's even there, is
> swiss cheese. I have to fabricate the radiator shroud, the whole front
> apron is basically gone including this channel. Even the cheeks where
> the fenders meet the apron are swiss cheese and the lower corners at the
> rockers were not there. I made them tonight and they look pretty good, I
> did make one cheek too but the apron and everything inside it is a bit
> tough.


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.237 / Virus Database: 270.11.9/1991 - Release Date: 03/09/09 
07:14:00



More information about the Spridgets mailing list