[Spridgets] 5 speed question

rrengineer @dslextreme.com rrengineer at dslextreme.com
Fri Mar 20 11:59:09 MST 2009


Yes, but if you have a clearance issue with the top of the tunnel, you won't
be able to slide it forward, which was my experience.  The way you describe
was the way I installed it.
Mike MacLean

On Fri, Mar 20, 2009 at 11:18 AM, Bill L <pythias at pacifier.com> wrote:

> Hello rrengineer,
>
>     When I put in the driveshaft, I just reach down the shifter hole
>     and pick up the yoke and start it on the output shaft.
>
>     And then there's the masking tape method.... ..
>
>     no need to cut and weld OR fight the whole assembly as one piece
>
> --
> Best regards,
>  Bill L.                           mailto:pythias at pacifier.com
>
>  '66 Sprite MKIII HAN8L49403   "the red thing"
>
>  Xerox never comes up with anything original.


More information about the Spridgets mailing list