[Spridgets] Venting... a 1275 w/ Weber

[Ron Soave]

--- On Wed, 11/11/09, Peter Caldwell <peter at nosimport.com> wrote:
> How are y'all accomplishing crankcase
> venting with a side draught Weber on a 1275?

For the intake Cannon manifold, I drilled and tapped a pipe thread where the flat is (the spot for Mini brake booster, I think). I did not run a balance tube and 1&2 were always a bit lean. I'd add a balance tube if I were doing it again. I used a chrysler K-car PCV valve. For Maniflow intake, I'm not using one (successfully) but I'd weld in a cross tube with a hose barb to go to a PCV valve.

Ron