[Spridgets] Could be LBC Rivnut cool product with video link

[derf]

In my experience using a screw to set them doesn't work very well at
all, at least not with the 10-32 Aluminum inserts.  I tinker with
surplus military generators and some have 10-32 threaded inserts used
to mount panels.  Trying to set the inserts the military uses with a
screw is useless.  I was able to make a tool from a HF hand riveter
and a 10-32 screw that would draw the inserts up nice and tight.  For
light duty or infrequent use Aluminum threaded inserts are fine, but
if you want heavy duty use and/or frequent use then you will need
steel inserts and a good setting tool.

On Sat, Dec 3, 2011 at 6:31 PM, Bob Kitterer <bkitterer at me.com> wrote:
> Unless you are going to use them with thick metal, greater 1/8 inch non- Al,
you can just use a screw and washers to pull them in place.  I used a couple
of these from electronic chassis parts on the back of the BE to hold the rear
license plate