[Spridgets] 1960 Bugeye clutch slave bleed?

dwramsey at att.net dwramsey at att.net
Sat Sep 10 19:54:06 MDT 2011


That is stock it is the big hole they cut to replace the rear tranny seal that
is a modification.  Best I can remember a off set boxend wrench works best.
                Crash




I seem to remember access through an opening on the
inside passenger side of the 
car, though that may have been a "modification"
Steve
Sent from me.


We cannot reach the bleeder valve; it is under the
starter and fairly close
to the outside of the passenger's footwell wall. I
sense it needs replacing
so we may pull it out, and bleed the new one before
reattaching it to the
bell housing. ...bill in corvallis


More information about the Spridgets mailing list