[Spridgets] Work bench surface
Mark Haynes
220caribou at gmail.com
Mon Apr 11 09:00:01 MDT 2016
Trevor-
Try online metals, I've had good luck with them when I need 304L in odd
sizes.
You'll have to cut and paste,but it'll get you to the sheet SS page.
http://www.onlinemetals.com/merchant.cfm?id=232&step=2&top_cat=1
or Service Steel Aerospace, though they are in the PNW,
http://www.ssa-corp.com/en/materials.php
HTH,
Mark Haynes
It only goes one way- Pay It Forward
I have a small workbench in the corner of my home garage that is 23" x 52".
The bench top is actually just made from scrap 2x4's and it has always had
a sheet of aluminum on it for a surface. The aluminum was too thin and has
seen better days so I want to replace it with stainless steel. I've been
watching Craigslist for an old kitchen prep table but they all seem to
bring good money.
The question: If I were to just go out and buy a sheet of new stainless
for the bench surface ... what gauge would be sufficient?
Alternate question: Any other suggestions for something to use as a bench
top surface?
-Trevor
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20160411/2686c933/attachment.html>
More information about the Spridgets
mailing list