[Spridgets] Sprite Mirror bracket

[Weslake1330]

I think the contents of any mug would spill while I was driving!

On Tue, 5 Nov 2019 at 15:14, Allen Hefner <lbc77mg at gmail.com> wrote:

> Daniel,
>
> It looks like you would have enough room to fit a cup holder on the
> trailing end of the bracket! I found that there isn't enough room inside
> the car for one.
>
> Allen Hefner
> Norristown, PA
> Sun City Center, FL
>
> *Current:*
> 2016 Subaru outback somewhere
> 2006 Chebbie
> *Former:*
> 1963 Sunbeam Alpine Series III
> 1967 Triumph TR4A IRS
> 1964 VW Type I
> 1967 VW Type II
> 1967 Rover 2000TC
> 1977 MG Midget (Sniff!)
>
>
> On Sat, Nov 2, 2019 at 2:45 PM Weslake1330 via Spridgets <
> spridgets at autox.team.net> wrote:
>
>> Hi List,
>>
>> I've just finished making my first mirror bracket.  Well actually it's
>> the second because I abandoned the first one part finished as it wasn't
>> quite right.  I'm pleased with the end result but I'll be making another
>> one as this one isn't quite perfect.  Yep, it does stick out a bit from the
>> bodywork (just under 3 inches) but its supposed to because being close to
>> the car's bodywork makes it much less aerodynamic (air sees a bigger bulge
>> than the actual mirror).  Very wet here so it may be a week before it gets
>> road tested - the worst that can happen is that it vibrates and I need to
>> use thicker aluminum sheet (this was 1.2mm) or stainless steel sheet.
>>
>> Photos attached.
>>
>> Regards
>>
>> ------------------------
>>
>> spridgets at autox.team.net
>>
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation: $12.75
>>
>> Archive: http://www.team.net/pipermail/spridgets
>> http://autox.team.net/archive
>>
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/spridgets/lbc77mg@gmail.com
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20191106/5e618cfc/attachment.htm>