[Tigers] Brake Mastery Cyl Threads?

[Ron Fraser]

Terry
	As far as I know all the brake line fittings are 3/8x24 with bubble
flare.  Confirm that with a 3/8 x 24 die on the line fitting you have just
in case someone change the brake system.

You will need a bottoming tap to clean those threads.

If you do not have a bottoming tap; take any 3/8 x 24 bolt and cut 2 or 3
good grooves down the length of the bolt and use it for a tap.   Use grease
on the tap to hold the cut chips and be careful not to dig into the area
where the bubble makes the seal.

Ron Fraser

-----Original Message-----
From: tigers-bounces at autox.team.net [mailto:tigers-bounces at autox.team.net]
On Behalf Of Terry Packer
Sent: Wednesday, November 19, 2008 1:57 PM
To: Tigers at autox.team.net
Subject: [Tigers] Brake Mastery Cyl Threads?


I have a stock Girling 7/8" brake master cylinder which needs the female
threads for the outlet pipe cleaned up - ie, the female threads for the pipe
which goes to the booster. Can anyone confirm the correct size and pitch for
those brake line fittings?

Thanks
Terry Packer
9470018
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.175 / Virus Database: 270.9.7/1799 - Release Date: 11/19/2008
8:58 AM