[Tigers] Carb Size Calculator Tool

[Dave Munroe]

Hi Sandy;

Thanks for this. You have proven what we all should know intuitively, (that 
we over-carbureted our engines) assuming your calculations are correct.
And of course without going to a dyno as you have suggested, we will not 
know for sure.

But in my case, I have a bored and stroked 289 that measures out to 331 cu. 
in. and I have a 5500 rpm limiter chip in my 6AL MSD fire generator, so
with the 600 cfm Edelbrock I have on my intake manifold, my carb is quite a 
bit oversize. (by your calculation should be 474 cu in.).

Much more fun though to talk about the 600 on there...474 doesn't sound all 
that impressive.

Must be why some guys have 700's with mechanical secondary's on their 
289's....

Bragging rights!

Dave




----- Original Message ----- 
From: "Sandy Ganz" <sganz at pacbell.net>
To: <tigers at autox.team.net>
Sent: Wednesday, October 15, 2008 3:41 PM
Subject: [Tigers] Carb Size Calculator Tool


 Just did another simple tool for calculating Carb Size and assorted visual 
charts. The link might get changed down the road but for now here it is...