[Tigers] Door Glass

[Mike Michels]

You will need to unbolt all six (I believe it is 6) bolts that hold the 
regulator assembly to the inner door panel. Also there is a plastic stop at 
the end of the channel that is at the bottom of the glass, so remove that. 
Then, while supporting the glass at a mid-raised position and while swearing 
profusely, work the regulator around (may need to crank it up and down to 
find the right angles) until you can slide the spring-loaded studs off one 
end and then the other of the track at the glass bottom. it's hard to 
describe and even harder to photograph ( I tried, photo attached) but after 
a lot trial and error, the glass will eventually be liberated and you can 
then extract the window and the regulator.

AAA glass had good advice on removing the channel from the glass, but mine 
was so stuck I had to take it to a glass shop

Good luck.
----- Original Message ----- 
From: "Clyde McLaughlin" <clydemclaughlin at verizon.net>
To: <tigers at autox.team.net>
Sent: Monday, October 27, 2008 5:05 PM
Subject: [Tigers] Door Glass


> Hi Listers,  I recently started to rpl a scratched door glass,  all went 
> well
> untill the manual said pop the regulator arm from the track slide on the
> bottom of the glass,  I pryed evenly and forcibly,  but the regulator arm 
> pin
> did not pop out of the slide piece,  Am I missing something??  Clyde
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> Tigers at autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive 

[demime 1.01d removed an attachment of type image/jpeg which had a name of PB070126.JPG]

[demime 1.01d removed an attachment of type image/jpeg which had a name of PB080157.JPG]