[Tigers] Front turn signal wiring

[Ron Fraser]

Kim
	Amber is the turn signal

Clear is the marker

Ron Fraser

-----Original Message-----
From: tigers-bounces at autox.team.net [mailto:tigers-bounces at autox.team.net]
On Behalf Of Fabbro
Sent: Saturday, October 24, 2009 10:58 AM
To: tigers at autox.team.net
Subject: [Tigers] Front turn signal wiring


I am at the rewiring the car stage for my wife's 1965 Tiger Production
number 40. I never owned, rode in or seen a Tiger on the move (Except Utube
and a local race track) before. I have built a diode protected relay board
with a 20 slot fuse holder to separate all the individual electrical
circuits Along with this a rev limiter circuit that doubles as a kill switch
to immobilize the car in case of theft. On this board I installed the
voltage stabilizer, starter solenoid and located it under the fake floor for
easy access for service reasons in the future. All this will bring the
electrical up to a modern day standard so I will not be stuck in the dark
with the Lucas electrical technology. Here comes the silly question. Up
front I have a small clear lens and the larger amber lens. Which is used for
a marker light and which is used as the turn signal light? On the current
day cars amber can be used as a marker/clearance light. On the rear I'm safe
it has an all red tail lenses.

Thanks again
Kim
You are subscribed as rfraser at bluefrog.com

Tigers at autox.team.net http://autox.team.net/mailman/listinfo/tigers

http://www.team.net/archive
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.423 / Virus Database: 270.14.27/2453 - Release Date: 10/23/09
06:56:00