[Tigers] Servo and F4B maniforld
Rollright at aol.com
Rollright at aol.com
Sun Dec 2 09:10:11 MST 2012
Hello,
In preparation of re-installing a rebuilt servo, I looked at my original
iron 2 bbl. manifold sitting on a bench, and spotted where the vacuum
fitting is located.
Under the hood of my Mk 1A is an Edelbrock F4B. It appears that the
attachment point for vacuum is at the rear end of the manifold, not pointing up
but pointing towards the firewall.
Does anyone know if this is correct? And is the fitting the same diameter
and thread as the original manifold?
Seasons greetings to all,
Jim Armstrong
Mk 1A
382002083
LRXFE
More information about the Tigers
mailing list