[Tigers] Brake Booster Hose Clamps

[Ron Fraser]

Joe

                The Book of Norm lists the many original style hose clamps.  There is a wide variety of types and sizes used and some have no exact reproductions available.   Some of the original hose clamps you have should be renewed for use again unless you found a replacement.

 

Radiator –  large double wire clamps – Mustang catalogs and the like carry them

Heater hose – Ford tower clamps  - Mustang catalogs

Heater hose - English band clamps on the ½” heater hoses – I never found a replacement for this style – that may have changed now – re-use originals if possible

Heater hose –  the smaller double wire clamps – Moss and others carry them – some are not like the originals

 

PCV hose – Corbin single wire clamp – Mustang catalogs

 

Original clamps at the fuel filter were a crimped style clamp – the current spring style is much easier to work with.

 

If you need to use a worm gear clamp anywhere I suggest the embossed worm gear style clamp instead of the perforated style.

 

Ron Fraser

 

From: Tigers <tigers-bounces at autox.team.net> On Behalf Of Joe Brown via Tigers
Sent: Saturday, February 16, 2019 8:46 PM
To: jimmc13 at socket.net
Cc: Tiger Group <tigers at autox.team.net>
Subject: Re: [Tigers] Brake Booster Hose Clamps

 

Thanks for the link. I'm going to try and clean up the old ones but it is good to see a source for new ones.

 

Next question. The Book of Norman says most of the 1" hoses used a Ford band clamps. Does anyone have a photo of an original clamp as used on the water pump bypass hose? I don't really want to just use a worm gear clamp.

 

Thanks,

Joe

 

On Sat, Feb 16, 2019, 7:08 PM <jimmc13 at socket.net <mailto:jimmc13 at socket.net>  wrote:

Joe:

Try this url, a little pricey but they also state they have other sizes;  19mmin diameter, 5 mm wide, check it out...Cotter Pin Type hose  clamp.

www.authenticclassics.com/ <http://www.authenticclassics.com/> 

Good luck.

Jim McLaughlin

B382000175 LRXFE

 

 

 

 

 

 

 

 

On 02/16/19, Joe Brown via Tigers wrote:

Happy Saturday, 

 

What is this type of hose clamp called?  They were on the hose that went from the brake booster to the intake manifold.  I haven't seen anything like this anywhere else.

 



 

Thanks,

Joe Brown

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20190217/87b6e214/attachment.html>