[TR] head gasket and figure of 8 gasket
Andrew Uprichard
auprichard at comcast.net
Tue Jun 10 04:49:47 MDT 2008
If anyone is interested, I recently had my TR3 engine rebuilt with 89mm
pistons. I had a honing plate made whereby the liners could be bored under
torque. Don't know if I'll ever use it again (this is my second
restoration, after all), but if anyone wants to borrow it, let me know.
It's aluminum, so reasonably light.
Andrew Uprichard
Sherborn, Mass
-----Original Message-----
From: triumphs-bounces+auprichard=comcast.net at autox.team.net
[mailto:triumphs-bounces+auprichard=comcast.net at autox.team.net] On Behalf Of
Randall
Sent: Monday, June 09, 2008 9:09 PM
To: triumphs at autox.team.net
Subject: Re: [TR] head gasket and figure of 8 gasket
> For the TR3 4 cylinder motor.
> Is the head gasket different for the 87mm liners, as opposed
> to the standard
> 83mm?
Yes, but the 83mm gasket is virtually impossible to find these days.
> Steel or copper for figure of 8 gasket?
Mine have always been copper and worked well. The steel ones might work,
but I've never tried them.
Randall
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as auprichard at comcast.net
http://www.team.net/archive
More information about the Triumphs
mailing list