[TR] Wheel Camber & alignment TR3A
Ibsen Dow
flashtr3 at cox.net
Wed Jun 25 08:10:36 MDT 2008
Hi Mark,
The shop indicated to me that the slight drift to the left was due to the
camber on the left side was 2 degrees positive and right side was .5 degree
positive.
He definitely said camber. He thinks that the ball joint on the left side
needs extra washers to bring the alignment within spec. I think the problem
like you, lies in the that vertical link may have a slight bend. I have an
extra vertical link that needs only a new stub axle. I thought if compared the
two, I might be able see if there was a bend.
Regards,
Ibsen
----- Original Message -----
From: Mark Vaden
To: Ibsen Dow
Cc: triumphs at autox.team.net
Sent: Tuesday, June 24, 2008 2:26 PM
Subject: Re: [TR] Wheel Camber & alignment TR3A
Are you sure they did not say too much castor? My TR4 street car
castor was wrong on both sides of the car. One side was due to a bent
vertical link, and the other side was due to a bent frame.
-Mark
More information about the Triumphs
mailing list