[TR] TR3 Windscreen glazing

[TeriAnn J. Wakeman]

Scott Suhring wrote:
> I did a bit of a dry run with the glazing (this is rubber and not the
> original cloth like material that was used by the factory) and found it very
> hard to avoid all binding on the corners. It would require lots of cuts and
> removal of rubber. Would you think it could be okay to only place the
> glazing on the straight sections of the windscreen (sides, top and bottom)
> and not do the corners?  Other Lister's experience in doing this? Thanks. 
>   

After hours with nothing to show but sticky glazing goo all over the 
place and an incomplete project I went to my local automotive window 
replacing company and had it done.  Fast, cheap & no mess ... the second 
time.

If that job needs doing again on my TR or my Land Rover, without 
hesitation I will let the pros do it

Teriann
'61 TR3A
60 Land Rover