[TR] TR6 Inside Door Handle Installation

Jerry Van Vlack jerryvv at roadrunner.com
Mon Jan 17 15:43:37 MST 2011


Darrell,

Try placing the pin in the hole of the handle and have it slightly protrude 
into the shaft hole in the handle before slipping it onto the shaft. With 
one hand holding the panel back against the spring and with a finger from 
the other hand on the end of the pin as you install the handle you'll feel 
the pin drop into the hole in the shaft. Once there use something larger 
than the pin to push it through the shaft. Bob's your Uncle.

JVV
----- Original Message ----- 
From: <TR250Driver at aol.com>
To: <triumphs at autox.team.net>
Cc: <6pack at autox.team.net>
Sent: Monday, January 17, 2011 1:26 PM
Subject: [TR] TR6 Inside Door Handle Installation


> Hey Guys,
> I have about an hour in it now with Beverly helping.  No  success, we just
> gave up.  Trying to get that little barrel into both  holes with the 
> springs
> behind the door is impossible!!!!!  I have done  this before but I think I
> always coped out and took the springs out.  Then  it is just very 
> difficult.
> I have the door glass replaced, the panel back  on and all I need is the
> handles back on.
>
> I hear there is a special tool for this.  Anyone know where I can buy 
> one?
> Any tips on how to make this job possible?  I tried using needle  nose
> vise grips & needle nose pliers.
>
> Thanks,
> Darrell



More information about the Triumphs mailing list