[TR] TR4 front end bacing
G.D. Huggins
guy at genfiniti.com
Tue Jan 29 14:13:42 MST 2013
Anthony,
I get it now.
I did this on my 4A.
It was a matter of welding some strengthening gussets to the chassis mounts,
and using the two-bolt brackets from a TR6.
I have descriptions and photos on my web site at:
http://www.genfiniti.com/triumph/restoration/chassisRenew.asp
http://www.genfiniti.com/triumph/restoration/frontSuspensionRenew.asp
Hope it helps. Best of luck.
On Jan 29, 2013, at 1:49 PM, Anthony Cascio wrote:
> Sorry, it's a TR4A on a solid axle frame. And I believe it's the bracing
setup for the lower A arms where they attach to the frame.
> Evidently they were not welded as good as they could have and the single
bolt where the new kits have a two bolt set up.
> I just wondered if anyone had done this already and if there were any photos
available before I attempt this upgrade.
> Thanks
> Tony Cascio
More information about the Triumphs
mailing list