[TR] TR-3 Parking brake handle

[Stan Foster]

There is also a nyloc that goes on the end of the pivot bolt after it has been screwed through the threaded tube in the frame. That nut can be a challenge to get on if the exhaust is in place.

Stan

From: Triumphs [mailto:triumphs-bounces at autox.team.net] On Behalf Of Bob Labuz
Sent: Wednesday, December 23, 2015 7:13 PM
To: JOSEPH MATO <joemato at sbcglobal.net>; triumphs at autox.team.net
Subject: Re: [TR] TR-3 Parking brake handle

Joe,

The parking brake handle is easily removed/installed while floor is in place. There is just one large bolt that acts as a pivot. Just remember to not loose any of the parts! Actually not too hard of a job compared to other tasks during restoration.

Bob

On 12/23/2015 06:32 PM, JOSEPH MATO wrote:
We took the right side floor out and the parking brake handle was removed. It would seem you can install or remove the handle with the floor panel in place. Has anyone had experience with this?  regards,  Joe Mato


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/triumphs/attachments/20151224/395ae057/attachment.html>